I'm currently going crazy with my quad-copter because I can't get the motors to turn.

This quad-copter is being built from the ground up, with a 3-D printed frame.


I connect the motors to the ESC and they beep doing be be be showing that they are connected. However, the arming sequence doesn't work and the motors don't turn.


Drone specs

Receiver: FrSky X8R

Remote: Taranis Q X7

Flight controller: Naza M Lite

ESC: Cicada 4 in 1 30Amps


INFO about current situation:

The receiver and remote are correctly bounded and you can see a solid green light on the receiver. The flight controller has been connected to a computer and you can see on the Naza assistant that when you move the remote's levels there is a reaction so everything seems to be set up correctly using the S-Bus.

I have bypassed the flight controller connecting the receiver and ESC to the power supply and a dummy servo tester got the motors to turn so they're able to recieve a signal and move.


If anyone has any idea about what's going on, it'd be very very helpful to let me know so I can test it out and reply with the results.


Thank you!